BMW N52/N54/N55 Steel Flange ONLY


This Hard Part’s Already Done. This Steel Flange Bolt On To Your N5X – Fabricate Your Own Oil Pan!!!!


Pre-order NOW! A 11 gauge hot rolled steel flange, with all bolt holes ready for install. ,This part perfectly bolt on to your N52, N54, or N55 engine block! No interferences with Crankshaft Counterweights, Oil Pump, Or Front Crankshaft Pulley.

For your convenience, this kit comes with the following components:

  • Flange Only – Approximately 26″ x 15″ 11 Gauge Steel Hot Rolled

But you’re not alone in this swap! There is so much available to help you pull this off, read below for supporting products, companies, and hardware!

For Most Applications, we highly recommended E30 M20 Motor Mounts to have proper trans output driveshaft alignment and hood clearance. Poly or rubber will suffice. Condor or Garagistic have these mounts available.  If interested instead, you may opt to purchase the complete Front Sump Oil Pan Kit for N52/N54/N55 very well! Additionally, feel free to opt to purchase a 6 piece M12 Socket Head Cap Screw kit of hardware, 6pc for installation of the new brackets into your N5X engine block! Finally, and most importantly feel free to access our purchase/download page for the E30 N54 Swap Integrators Guide, which features these products, including details on wiring, air conditioning, power steering, mechanical/electrical, and SO much more!!

Installation is Bolt-On. Information on the brackets in development can be seen here!

We offer domestic shipping, flat rate. Moreover, we also offer international shipping to Europe, South America, and Russia. For any swap help, feel free to contact us here!

Additional information

Weight 4 lbs
Dimensions 28 × 16 × 1 in


There are no reviews yet.

Be the first to review “BMW N52/N54/N55 Steel Flange ONLY”

Your email address will not be published. Required fields are marked *